Your cart is empty.
Your cart is empty.
Specification:
Material: Stainless Steel + Nylon
Color: Black+Red
Size: 1.7 x 1.6 x 1.3 Inches
Weight: 0.08kg
Package Include: 1 x red M8 double stud terminal + 1 x black M8 double stud terminal
-High quality nylon to increase the stability and strength of the product.
-Stainless steel material for extended use. They can work well in humid environments.
Evelyn olvera
Reviewed in the United States on May 3, 2025
Worked good no defects
Yao
Reviewed in the United States on May 2, 2025
work as it should
Chris
Reviewed in the United States on May 19, 2025
Overall happy with this item, not only did they supply additional pieces and screws but worked well. Do be careful don’t over tighten as the plastic does brake
Josh B.
Reviewed in the United States on August 21, 2024
This was supposed to be a two-piece package with mounting hardware. What I received was a single terminal with no mounting hardware.
kj
Reviewed in the United States on November 9, 2023
I'm installing an electric trolling motor on my boat. The battery will be stored under the front deck so I will be running cables that will run to the bow where they will be tied in to positive/negative junctions. I ordered these BELOMI junctions as the tie-ins to the battery and my trolling motor cables. For the purpose of this review I hooked everything up “above deck” to make sure it hooked up and worked correctly. I did switch out two of the stainless steel bolts with wing nuts so I can easily disconnect my trolling motor at the end of the day and recharge my battery. Everything worked perfectly. The 5/16 studs worked great with both the battery and motor cables. The price point ($10) is about what I would expect since everything is stainless steel for marine applications. Five stars with ease.
Mark J.
Reviewed in the United States on November 8, 2023
5/16 stainless hardware is really nice with stainless mounting screws as well. The housing base is made of a really thin plastic and has a cover that snaps in to access the bolts. If you're using light wire and not really torquing the nuts down too much these should be fine. But if you're connecting heavy gage wire >10awg you'll need to be careful not to crack the plastic from over tightening or from wire stress. The photos are shown with 2AWG lugs that are mine and not included.
D. Lavren
Reviewed in the United States on November 11, 2023
This is a set of two battery wiring blocks. There is one red and one black color coded block. There are also four mounting screws. Each block has two M8 stainless steel threaded studs along with a jumper bar. Each stud also has a stainless steel hex nut and lock washer. The high performance plastic body has two moulded in mounting holes. The heavy duty blocks will help to organinze and secure mutliple wiring connections. The blocks can be used in a variety of applications like autos, trucks, RVs, boats and buses.Would recommend these to anyone.
JWalch
Reviewed in the United States on October 20, 2023
I had been wanting to install a second battery in my vintage 1953, 45 foot Chris Craft Cruiser for a while because all the new electronics and electricals were really taxing my one battery system at night when I didn’t want to run the auxiliary generator because of the noise. I wanted to install two 300 Ampere Hour batteries, but because of their size and weight, I would need to place one of them on the port and the other on the starboard side of the engine compartment. With these terminal blocks I was able to connect them together in the center of the bulkhead with individual remote safety disconnect switches. Using these terminal blocks made for a quicker, neater, professional looking job. They'll work equally well for installing a second battery in a four-wheeler as well.
Recommended Products
$12.99
$ 5 .99 $5.99