Your cart is empty.
Your cart is empty.The Roger Kit upgrades your Brinly cart's standard bed angle to a full 180° dump, fully emptying the cart when you unload. This easy-to-install conversion kit is perfect for when you need to empty damp materials, such as leaves, mulch, soil and more. No matter what you need to haul, the bed is fully emptied every time, no raking or shoveling required. Just use the quick-release foot pedal and handle to fully dump the bed, lock it back in place, then move right on to the next job. Constructed in durable powder-coated steel, the Roger Kit can be added to any 10 cu. ft. Poly Cart manufactured by Brinly-Hardy (Models PCT-100BH, PCT-101BH). All new cart hardware and drill bit come included. Take Brinlys top-rated Poly Cart to the next level with The Roger Full Dump Kit; "Over and Out!"
diesel0147
Reviewed in the United States on July 21, 2024
Was just a dump bed kit. No frame or wheels. Far to expensive for what was contained. They should make it clear on the description.
maxSteel
Reviewed in the United States on June 29, 2023
I like this kit, it is solid and gives the cart a new capability it did not have.I don't like the new latch mechanism though, it sometimes does not want to engage.
Zero
Reviewed in the United States on December 18, 2023
It takes more time to install this full dump kit than it does to built the cart. It's definitely better to start off and install this kit when you buy the cart instead of doing it after but it only takes a few minutes to take the cart apart for the install.You have to drill holes in your cart tub to install this. The drill bit is included as well as a drill template for the bolts that go in the top edge. It's not hard to drill but there's a bit of wiggle room in where things go and I suspect that makes this not work so well in use. If the slots are out of line with the cart, the latch doesn't want to engage when you return the cart from dumping. I used a ruler and a square to center my bracket and line it up with the ribs of the cart. This took the guess work out of aligning the holes to drill.I find it really difficult to dump the cart most of the time. The metal from the V section holding the wheels is bowed a bit on my cart and it hits the latch bar. I don't really know of a way to fix this.At a price that is about half that of the cart I think I will skip this on the next cart I get. It's not that difficult to unpin the cart from the tractor and just lift up the wheels and flip the cart over.
Recommended Products
