Carburetor Carb for Kawasaki KX250 F KX250F Carb 2004-2010 Honda CRF250X CRF250R Suzuki RMZ250 TC250 TCI250 TE250 250XC 250SXF 250XCW

Replaces Part Number:

• 16100-KSC-L71
• 16100-KRN-A02
• 16081-KRN-671

Package Includes:

• 1 x Carburetor
• 1 x Fuel Filter
• 4 x Extra Main Jets #140 145 150 155
• 4 x Extra Pilot Jets #50 52 55 58

High Quality:

• This is Brand New and High Quality Product, Meet the Professtional Specification for Stable Performance

The installation steps for a carburetor can generally be followed in the order below:

1. Check the Carburetor and Accessories

Before installation, check the carburetor and related components for any damage, wear, or contamination to ensure they are in good condition.

2. Cleaning

Clean the surface where the carburetor will be installed, as well as the intake manifold, to ensure there is no dust or debris that could affect the proper functioning of the carburetor.

3. Remove the Old Carburetor

Before removing the old carburetor, disconnect the power (if there is an electronic control system) and fuel lines, and turn off the engine. Detach the intake and exhaust hoses from the carburetor, which are typically located at the bottom or side of the carburetor. Remove the securing screws, usually Allen screws or flathead screws (use a specialized carburetor screwdriver). Carefully lift the carburetor to separate it from the engine, taking care not to damage it.

4. Install the New Carburetor

Position the new carburetor in its original place, ensuring it is properly aligned with the intake manifold or intake port. Be sure the intake and exhaust ports are installed correctly (not reversed), and then tighten the securing screws.

5. Connect the Fuel Line

Attach the fuel line to the fuel inlet of the carburetor, ensuring that the connection is tight to avoid fuel leakage. Check the fuel line for signs of aging or damage; if any is found, replace it.

6. Secure the Carburetor

Use bolts to secure the carburetor to the intake manifold or the appropriate position, ensuring it is firmly in place without any wobbling.

7. Check the Electronic Control System (if applicable)

If the carburetor has an electronic control system (such as an automatic throttle control), connect the cables or wires, ensuring all electrical connections are secure and correct.

8. Adjust the Carburetor

Adjust the fuel/air mixture, idle speed, and other tuning screws according to the vehicle or equipment requirements to ensure smooth operation.

9. Check the Cylinders and Exhaust System

After installing the carburetor, ensure there are no air leaks in the intake system, that the cylinders are functioning properly, and that the exhaust system is clear.

10. Test the Engine

Open the throttle, start the engine, and observe the operation of the carburetor. Check for any unusual noise, fuel leakage, or stalling. Make fine adjustments if necessary.

11. Final Check

Inspect all connection points, including the fuel lines, cables, and bolts, to ensure they are tightened properly and there are no loose connections or leaks.

These steps are generally applicable to carburetor installations. Specific details should be referenced in the carburetor’s installation manual or the manufacturer’s instructions.