Your cart is empty.
Your cart is empty.Hydraulic Shop Press12-TonFloor MountWorking Range: Up to 27-1/2 in.Overall: 20.500 in. W x 53.125 in. HWeight: 103 lbs.Yellow Powder Coated SteelIncludes (2) Press Plates Features for JEGS 12-Ton Shop Press:Creates terrific force with very little effort for installation/removal of pressure-fitted itemsAdjustable table to raise/lower to the proper range/working distanceSpring return mechanism for quick and easy releaseCan also be used for an electric motor or armature repair as well as bending or straightening of metal
kevin
Reviewed in the United States on November 11, 2024
High quality shop press but arrived bent contacted JEGS and they sent the bent parts out fast and free of charge overall I’d say it’s worth the price used to press out a wheel bearing worked as it should
Austin bob
Reviewed in the United States on August 18, 2023
Product works great. Finished my transfer case on this w56 transmission today and I'll be finishing this tranmission next week. No bells and whistles to the press. It's simple and it works. It's a little sloppy but it does help make sure the surfaces your pressing remain parallel so I find it to be a plus in certain setups.
Melburn L. Gossett
Reviewed in the United States on October 7, 2023
Smaller than I thought. But ok.
Customer
Reviewed in the United States on December 3, 2020
This little press is the biggest piece of junkPut it together start coming down on my bearing and the bottom c-channel bends . If the jack pushes 12tons then the steel frame should hold 15 tons . Dont buy its crap see my pictures
A. George
Reviewed in the United States on April 3, 2019
Works good jegs is always great to work with I only got box 2of 2 when I first received jegs sent out the other parts asap the Jack was bad jegs replaced it without issue for the price it's what you would expect it's China made does the job for home projects...not a professional item
samuelcsnyder
Reviewed in the United States on June 10, 2018
First time using it to press bearing and race on a dana 44 axle the pin bent causing it to press on crooked. Had to cut the pin off and weld a thicker plate to the square bar. Not even useful for the diy garages. Go with the bigger
Kassady
Reviewed in the United States on April 20, 2017
A good tool for the price. I put it together in 15 minutes and pressed the bearing's for me rear end on in 10 minutes.
Jeffery Overman
Reviewed in the United States on October 19, 2016
Seems like a good product. Worked fine for the job I did.
Recommended Products
$132.00
$ 53 .99 $53.99