Shopping Cart

Your cart is empty.

Your cart is empty.

MyCableMart 2 1/2'' Cut-Hole Size Gray Round Wire Management Grommet w/Removable Lid

5.0 Write Review
Free shipping on orders over $29.99

$3.67

$ 0 .99 $0.99

In Stock
  • Domestic Shipping
  • A_GEN_TAX
  • Cut-hole Size Required: 2.5'' This is the size of the hole you will need to CUT
  • Inside usable diameter: 2.21'' This is the usable INSIDE area to pass wires
  • Grommet Insert Width: 2.459'''' This is the MEASURED width of the grommet


Organize your cables with professional desk and cabinet cable-pass through grommets. Cut hole to size specified and either press or glue into place.
Specifications:

  • Hole Size Required: 2.5.
  • Grommet Insert Width: 2.459
  • Grommet Lid Width: 2.972
  • Grommet Depth: Approx 0.625
  • Inside Usable Diameter (Approx): 2.21
  • Size Tolerances May Vary
    Important Installation Note: The Grommets are manufactured to be slightly less that the hole size. For example if we have a grommet advertised at 2.5 inches (example size ONLY) when measured on a caliper it will measure at approx. 2.459 inches - or approx .04 inches LESS than the hole size of 2 inches. This difference is by design to allow for the grommet to be inserted into the CUT hole size. These grommets after inserted into a cut hole are intended to move freely. If you need a TIGHT fit a small amount of glue or silicon may be needed.
    Please see technical drawing (Product Manual) below for size and shape details.