Shopping Cart

Your cart is empty.

Your cart is empty.

Round Cable Gland, Waterproof Cable Pass Through for Marine, Auto and Home, Split Seal Design Easy to Install (White)

5.0 Write Review
Free shipping on orders over $29.99

$16.99

$ 8 .99 $8.99

In Stock
  • Package Includes: Our cable gland set includes 1 compression ring, 1 deck ring, 1 rubber cable seal, 1 gasket, 4 hex nuts and 8 screws. A wide range of accessories can effectively meet your installation needs
  • Wide Compatibility: The waterproof cable pass through is designed to fit a wide range of cable diameters and connectors. Its versatility makes it ideal for nearly any application, from boats to cars
  • Waterproof Cable Routing: Made of quality plastic, our cable clam can withstand water splashing. The rubber cable seal will wrap the cable around tightly when it passes through, providing a secure waterproof seal that water will not easily travel along the wire. These make it suitable for marine and automotive use
  • No Need to Remove Cable Connectors: You can cut a slit to the hole you drilled so that the cable can be compressed around by the rubber cable seal. This design allows for quick and hassle free installation without the need to remove cable connectors, providing convenience for your installation
  • Note: The cable gland is only for use above the waterline. Do not spray it directly with a high pressure water gun


Package Includes:

Compression ring *1

Deck ring *1

Rubber cable seal *1

Gasket *1

Hex nuts *4

Screws *8


Specifications:

Maximum Cable Diameter: 0.56" (14 mm)

Maximum Connector Diameter: 1.40" (35 mm)

Fastener: Stainless Steel


Features:

1. Our cable gland waterproof provides a reliable cable fixation and protection, and it is perfect for a clean, professional look across multiple lines.

2. The split seal design allows for quick installation without removing the connector, saving the expense of replacing or removing the connector.

3. The rubber seal and gasket offer reliable waterproof cable routing solutions by compressing around the cable tightly.


Easy to Use:

1. Measure your cable diameter and drill a suitable hole in the rubber seal for your cable to pass through (The hole will be slightly smaller than the cable to ensure a tight fit).

2. Use a sharp razor blade and cut the rubber seal from the cable hole outward.

3. Fasten the deck ring and gasket to the surface, be sure to line up the four screw holes.

4. Slip the compression ring onto the cable and insert the cable into the slit of the seal. Press the rubber seal into the compression ring.

5. Screw the compression ring to the deck ring and tighten.


Note:

The cable gland is only for use above the waterline. Do not spray it directly with a high pressure water gun.