Your cart is empty.
Your cart is empty.Product Description
Mike D
Reviewed in Canada on February 6, 2025
Fits perfect and is good quality. If it was a bit thicker it would take the flex out of it.
Joe Mackenna
Reviewed in the United States on February 5, 2025
This zero tolerance plate is better than nothing. It’s plastic and not as strong or super flat as the plate that came with the saw.
pedro p.
Reviewed in Mexico on August 8, 2024
Llego muy bien , pero con la vibración se despegó la placa del extremo distal donde va la cuchilla de separación , al empujar la madera topa con esa plaqueta y es un riesgoSugiero mejorar ese aspecto
Mimi
Reviewed in the United States on July 10, 2024
This insert fits the Skil table saw as it should, and once you cut the slot for it (remember to remove the riving knife!), you are good to go. It provides a good, clean cut with little tear out, assuming your blade is sharp.
DS
Reviewed in the United States on December 13, 2024
Needed this to be able to cut thin strips on the table saw. Fit was good, well made, easy to set up and use. Makes it a lot safer.
Tyler L Hardin
Reviewed in the United States on November 17, 2024
The media could not be loaded.
Bear
Reviewed in the United States on November 12, 2024
Glad SKIL finally came out with this zero clearance insert. Fit my SKIL table saw (which I love) perfectly. Makes a huge difference when ripping off small pieces. Highly recommend this insert.
Jennie Crowley
Reviewed in the United States on October 29, 2024
I ended up making a slight mess installing this for the first time. I didn't take off my riving knife because there were no instructions. It still works very well. I ended up purchasing another one just in case. This one I will be sure to install without the riving knife for the cut through.
terry dobbins
Reviewed in the United States on October 26, 2024
I went by the YouTube instructions on raising the blade up to actually cut the zero fence and it shattered will not be buying another anytime soon I think I'll go with particle board and make me a new one
Nick Bondarenko
Reviewed in the United States on October 21, 2024
Fits my table saw but I noticed it doesn't sit as snug as my insert that came with the saw.Wobbles around a little while in the saw
Tony Wagon
Reviewed in Canada on April 11, 2024
Fit perfect. Able to adjust. Will buy again
Recommended Products