Your cart is empty.
Your cart is empty.Product Description
Multi-scenario use to meet your needs
VCE low voltage mounting bracket can meet a variety of wiring needs such as HDMI, coax, Speaker, RJ45 and so on.
Size and Details
Usage Scenarios
J. Swadick
Reviewed in the United States on March 16, 2025
Little less quality than home depot. But good enough for low voltage application.
mimzhan
Reviewed in the United States on February 26, 2025
Delivery was fast! Product works really well. Easy to install.
Gene
Reviewed in the United States on February 11, 2025
They work as advertised. It is a simple device; but the knock off versions get it wrong. These folks got it right.
Tim from Canada
Reviewed in Canada on January 15, 2025
These work great if you have to install cable, telephone, networking, even a plug in. It's just with a plug you have to brace the wire, not sure it's code. Works really good for audio visual hook ups, The price is very reasonable.
Alexander Bloom
Reviewed in the United States on April 8, 2025
Does the job. Stays sturdy in the walls
Rabbit
Reviewed in Canada on April 26, 2025
Much better than screwing plates to the wall. Works perfect.
Gurpreet Soomal
Reviewed in Canada on April 10, 2025
Works so far, good price.Worked on a Canadian/US Lexus IS 350 key fob.
André
Reviewed in Canada on September 20, 2024
Une prise Videotron et le résultat est excellent, aucune difficulté a l'installer. Je recommande ce produit qui élimine un petit problème de plaque.
SK
Reviewed in the United States on August 13, 2024
Mounting ethernet ports in my office down to my living room so that I can move my modem/gateway to a better location for the rest of my home. These will serve that need as expected.
Reviewed in Canada
Reviewed in Canada on July 14, 2024
This is a pack of low voltage mounting brackets. If you’re not running electrical cable and instead are running Ethernet, HDMI, speaker, etc. cable then you don’t require a full electrical box. You only need a bracket like this one, just to provide something for the wallplates’ screws to attach to.No instructions are included, but there are instructions in the listing. Basically, once you make the hole, there are two “wings” at the top and bottom that push against the drywall once you tighten it with the screws.The only issue is that the wings are blocked from rotating fully and these blockers are approximately 1-3/4” deep. Therefore, you will need that much room behind the wall. Normally, this is not a problem, but you might have some blocking (wood between studs) or other obstructions that might get in the way.
Tracey C.
Reviewed in the United States on December 12, 2024
Met my needs and expectations
Mr Person
Reviewed in the United States on October 4, 2024
There is a little bump where the screws are, so if you mark the wall with the provided dots, and cut perfectly, it will have trouble fitting, but a little pressure and it went in fine. As you can see I got these for Ethernet jacks, and everything fit fine. I do wonder if the threads will hold up if I have to take the face plate off and on as it felt like I was cutting the threads as I screwed on the plate, but I don't think I'll have to remove it often.
George Russell
Reviewed in the United States on October 25, 2024
I used these to install network and cable panels in homes that were already finished. Very simple to use especially if the distance between walls is very short.
Recommended Products