Shopping Cart

Your cart is empty.

Your cart is empty.

10pcs DRV8833 Motor Drive Module 1.5A Dual H Bridge DC Gear Motor Driver Controller Board

4.7 (2) Write Review
Free shipping on orders over $29.99

$12.99

$ 6 .99 $6.99

In Stock

About this item

  • DRV8833 2 Channel Motor Driver Module 1.5A 3V-10V H-Bridge 4-Wire Step Motor
  • Single H bridge output current: 1.5A, can drive 2 DC geared motors.
  • Built-in overcurrent protection, short circuit protection, undervoltage lockout and overtemperature protection. With low power sleep mode.
  • For DIY smart car robot, it can drive DC motors up to 1.5A and 4-wire stepper motors.
  • Input voltage: 3-10V，Size: 18.5*16mm


Description

Features

ULT PIN:Low level is sleep mode (need to disconnect the J2 short solder joint behind the module)

OUT1,OUT2:1-channel H-bridge controlled by IN1/IN2

OUT3,OUT4:2-channel H-bridge controlled by IN3/IN4

EEP PIN:Output protection.Default no need to connect.

VCC:3-10V

GND is grounded

Parameter

1. Size:18.5*16mm

2. Input voltage:3V-10V

3. Single H-Bridge output current:1.5A(It can drive two DC motor)

4. Overcurrent protection:YES

5. Short circuit protection:YES

6. Undervoltage lockout:YES

7. Overheating protection:YES

8. With a low-power sleep mode

Application

1. DC motor which drive current is less then 1.5A

2. 4-wire step motor

Package Including

10 * DRV8833 Motor Driver Modules


Hayden Whitaker
Reviewed in the United States on March 17, 2025
Very simple to use. Only complaint is that the pinout markings aren’t on both sides, but that’s a picky thing. They work great. I connected it to an ESP32 and had no troubles connecting it.
Customer
Reviewed in the United States on August 11, 2023
Very small... Nice tight places in small devices