Your cart is empty.
Your cart is empty. 5Pcs 12V Waterproof Push-Button On-Off Switch, Carbhub 12V Waterproof Push-Button On-Off Switch with 4" Leads For Motorcycle / Auto Car
Features:
1. LED push button switch with waterproof rubber boot
2. About 4 "(10cm) Wire Leads
3. Single pole switch
4. Rubber boot unscrews for flush mounting applications (requires drilling 5mm "hole)
5. Ideal for any application requiring a waterproof on-off push button switch
Specifications:
Operation: auto-lock
Operating Current: 3 (A)
Rated thermal current: 6 (A)
Contact resistance: 50 (Ω)
Insulation resistance: 100 (MΩ)
Packge list:
5x Waterproof Push-Button Switch
Warm tips:
1. Please allow 1-3 mm error due to manual measurement.Thanks for your understanding.
2. You have to seal with silicone where wires come in.
Melanie K Wood
Reviewed in the United States on June 7, 2025
The media could not be loaded.
Peter
Reviewed in Canada on August 13, 2024
Works great for replacement switches in rv fans
David L.
Reviewed in the United States on May 4, 2024
Work perfectly. Easy install.
Bear
Reviewed in Canada on March 18, 2024
Like the cost and quality. Really liked the efficient delivery
Tom
Reviewed in the United States on January 2, 2024
This switch was to replace a faulty switch on one of my ceiling lights on my boat. It was easy to install and works great!
Kevin D.
Reviewed in the United States on July 9, 2023
I bought 5 as a package good thing because had another go bad so worked great
Bonnie Lembke
Reviewed in Canada on November 13, 2023
Water resistant but not water proof
david
Reviewed in the United States on September 26, 2022
I put small cable ties around the switch body because after mounting the switch to my light fixture the back of the switch popped off and the switch guts flew out. Found all the bits, replaced them and the switch works fine. These switches are "waterproof" at the button only. The back of the switch body is a second plastic piece that clips on but it is not waterproof.
Chantal Tremblay
Reviewed in Canada on August 19, 2021
On reception, one of the five switches is defective
Diane Vilandre
Reviewed in Canada on July 27, 2021
produit de bonne qualite
SLick GT
Reviewed in the United States on June 18, 2021
The media could not be loaded.
Jon Stewart
Reviewed in the United States on December 11, 2020
Bought these to replace the push button switch for my bathroom 12v exhaust fan in my travel trailer. Fits perfectly and did the trick. Screw on button cover is like a rubber nipple which is supposed to make it water tight but it's definitely a cheap housing that cover screws into. Any tension on the wires causes a visible separation of the seam of the housing so I can't see how this is waterproof. I checked other switches in my package and they did the same. Nevertheless it works now. We'll see how long it lasts. I got 5 of them in the order so I got backups. Minus a star for calling waterproof when is clearly not.My application will have moisture surrounding the entire part., However they did include rubber washers with the screw in rubber switch cover so if your application will only have moisture on the switch side, you might not care about the housing separation.
Mark C Robinson
Reviewed in the United States on October 4, 2020
This is a solid button. Click locks between on and off. It wound up being slightly bigger than anticipated so it won't suit my purposes, at least for this project. Glad to have them none the less.Dims of the rectangular bit are 18mm L x 14 mm W x 8 mm HIt looks like you'd want a 9mm diameter hole for the threaded post and the post's height from base to button tip is about 15mm.This makes the overall height 23mm.The leads are about 4"You could pry it apart and modify it to lose up to.. I'd say 25% of the length. It would then have an opening for dirt and moisture to contend with, but it could be sealed pretty easy.
Recommended Products
