Your cart is empty.
Your cart is empty.This Engine Upper Intake Manifold compatible with 2007 - 2008 F'-ord F'150 E-150 E-250 Lobo (Mexico) V8 281 4.6L; VIN W.
Steve Barron
Reviewed in the United States on May 3, 2025
Right part , engineered better than original intake , my van runs great !
brandon
Reviewed in the United States on February 5, 2025
My vehicle: 2007 Ford F 150 4.6L v8This intake manifold is not made correctly. The screw holes for the fuel injector rails are misaligned, causing the fuel injectors to sit crooked, causing the injectors to pop out of the fuel rail when driving. It already happened 3 times since I've installed this intake manifold.The plastic all around is cheap, warped, has plastic flakes along the edges that you need to shave down.The screw ports on the intake manifold are just plastic holes. On the Ford Intake manifold it has brass plates for the screw ports to bolt into. On this manifold, you literally need to use wood screws to drill into the plastic to hold down the Fuel Rails & the EGR Valve. These holes will surely strip after driving this for a couple months.The intake ports had plastic flakes on the edges that I needed to shave down.There's no instructions and they just give you a bag of wood screws and random spacers to use. I ended up using 2 spacers on the EGR Valve to Intake Manifold holes because the EGR Valve sits crooked too.I ended up with extra random spacers that I don't know if I need to use them or not.In order the fix the Fuel Rail popping off the injectors, I had to buy nickel sized washers from Home Depot to use as spacers between the Throttle-Body-Electrical-Plug-sided-fuel-rail & this intake-manifolds-screw-holes. So far this seems to have corrected the misalignment issue, we'll see.I will most likely return this intake manifold, as it is causing more issues.Buy a Ford Dealer intake manifold instead of this, trust me, this thing is cheap for a reason.
Desiree
Reviewed in the United States on September 1, 2024
It fit great but one thing I don't understand is the water port in the back that the motor has no use for can any body tell me what to plug it up with because I keep blowing a rubber cap when they get old and dry and I have to stop because I don't want to blow my motor so can anyone help on that any suggestions would be nice thanks
Marta Berrios
Reviewed in the United States on October 21, 2024
fits good
Recommended Products
$59.99
$ 25 .99 $25.99