Your cart is empty.
Your cart is empty.Product Description
James Dean Klein
Reviewed in the United States on August 6, 2024
As advertised
Willie
Reviewed in the United States on July 26, 2024
Great price jet ski
Justin B.
Reviewed in the United States on July 10, 2024
Exact Replacement as OEM. Worked great on my 1993 Yamaha Wave Runner 3. Shipped fasted and arrived well packaged.
the grouch1976
Reviewed in the United States on June 8, 2024
these fit perfectly
Andre Charlebois
Reviewed in Canada on September 30, 2023
Not good quality . Poorfit onsome of the components
Amber Silberschlag
Reviewed in the United States on March 15, 2023
It was ok
andre
Reviewed in Canada on October 3, 2023
apres 1 mois le kit rapetise et ne fonctionne plus a capacité et jai sauter le moteur qui avait été fait en neuf
Customer
Reviewed in Canada on October 6, 2022
Excellent quality rebuild kit. I’m happy and most importantly, my seadoo is happy.
Mitch
Reviewed in the United States on April 25, 2021
Buy SBT or genuine mikuni kit, none of this kit is usable. The shoulder on the fuel filters is too thick which will cause a leak, the gasket for the pump side of the carb is too thin, does not seal. The spring was the wrong strength. the fuel pump check valve grommets were too small, and the diaphragms were defective. once the carbs were back together, they leaked and the diaphragms were pushing on the needle valve (which had an incorrect pop of pressure anyways due to the wrong spring rate) and this caused the engine to run incredibly rich while spraying fuel out of the side. As soon as the engine was shut down, the faulty diaphragms flooded the engine. This kit will literally make your carbs do everything you do not want them to do. source a proper kit, and wait for it to show up. It will be worth it.
Dave
Reviewed in Canada on February 2, 2020
Quick shipping. Everything fit exact except for 2 pieces which didn’t really have to be changed anyway. Great price
emilio guglietta
Reviewed in Canada on December 3, 2019
Good
Samantha Lightfoot
Reviewed in the United States on June 25, 2018
I was skeptical about buying a non-Mikuni rebuild kit after all the horror stories that I read on SeaDoo forums. I was rebuilding a 1992 SeaDoo GTX that had sat around for the last 14 years and needed to rebuild the carburetors.When this arrived, I tore down both and got to cleaning/rebuilding. The kit looked good and included quite a few extras (including the four different springs needed for various carb setups. If I had complaints on this kit, they would be that the included springs are not "color" coded so that you know the size. In the Mikuni kits, they are silver, bronze, etc. However, I reused the original springs since they looked good. The other would be that this kit doesn't include the needle valves/seats, but I knew that when I ordered it so I also ordered the Mikuni Twin Carb 2 Pack Needle Valve Seat from Amazon.You MUST make sure that you take great care to evenly torque down the fasteners and DO NOT over-tighten. The seals/gaskets will do their job very well without putting the torque of an impact on it. Just take your time and do half turns one each fastener like you're changing a tire. I had over-tightened the mag side carb and it wouldn't hold pressure at first. I opened it up again and took greater care when reassembling - no issues. I'd definitely take a chance on this kit. All gaskets seemed to be cut to spec and everything lined up correctly. The price is definitely right compared to the OEM.
edj0nes01
Reviewed in the United States on February 14, 2018
No needle in this kit, not complete in my opinion. But what is there is good replacement for wore out parts.
Recommended Products