Your cart is empty.
Your cart is empty.Product Description
Product Description
Real Wood Edge banding with Hot Melt adhesive
The birch wood veneer edge banding is made of premium quality wood with smooth surface and natural grain.
Pre-glued with hot iron Adhesive
It is Pre-glued iron on With high quality adhesive and finely sanded to perfection.
Natural Texture
Pre Glued Edge Banding made by real wood:
Red Oak,Black Walnut,Cherry,Maple,Birch,Beech,Okoume,White oak,Pine
How to use
Our wood edge banding tape can be used for different kinds of furniture Cabinet and DIY projects, which can painted with a lacquer finish to match your projects.
White Birch Wood Veneer Edge Banding
ebpsneer Birch Wood Veneer Edge Banding is made of natural wood, it is easy to process and durable.
Our wood veneer is pre-glued with top-quality hot melt adhesive that provide a strong bond, it also can be remove and reheat.
The glue is activated by heat and will strongly apply this high-quality veneer edging onto your shelf, furniture,cabinet,plywood,MDF,partical board,OBS board or wooden DIY project.
It's easy to use,just apply it to the furniture edging and iron on with a household iron.
Size 1: 2" x 50'( 50mm*15m)
Size 2: 3/4”×50’ (19mm*15m)
Size 3: 1/2”×50’ (13mm*15m)
Size 4: 7/8”×50’ (22mm*15m)
Size 5: 1-1/2”×26’ (38mm*8m)
How to Apply for Furniture
Wood edge banding roll can be applied with an iron, hot air blower or it can be applied with an edgebander machine. Trimming and sanding as required after the glue turning dry.
Use a steam iron or dry iron,Do not use steam with water, dry heat is required.
Switch to "Fleece" or similar gear, then hold for about 3 seconds and move forward(Don't press it too long, otherwise it will burn the edges).Before operation, try for a short period to master the method. If the hot melt adhesive does not melt or burns the edges, please adjust the pressing time or gear appropriately.
Simply use household iron, hairdryer with hot wind or edge banding machine to attach. Trimming and sanding as required after the glue turning dry.
EASY APPLICATION
1
You simply hold the edge banding in place, run over it with a household iron to heat the adhesiv
2
Wait for the edge banding cooling 10 minutes
3
Use the back of a utility knife or other tool to scrape off the burrs on the edge banding
4
Finished