Your cart is empty.
Your cart is empty.Product Description
2 Colors Available
Hernz
Reviewed in the United States on June 8, 2025
The media could not be loaded.
SANOJ MALAP
Reviewed in the United Arab Emirates on March 12, 2025
Gives a good look over all and are very bright and visible…. Sadly less than a year and the driver side stopped working
Customer
Reviewed in the United States on January 7, 2025
Recently I purchased some Vland headlights for my 2013 Challenger that are meant to mimic the newer models. I knew they wouldn't be a perfect fit, but I was determined to make these work anyway. After cutting out every single mount to make them fit and adding rubber and new mounts to keep them in place, along with wiring, I could not be happier with how these look. So to anyone wondering about their older Challenger, with some Vland headlights, patience, and creativity, you can make these work!
adriel
Reviewed in the United States on April 25, 2025
Very easy to install looks like a demon
Ricardo Rdz.
Reviewed in Mexico on April 13, 2025
Excelente producto, muy buena calidad
Wyatt
Reviewed in the United States on September 25, 2024
They look great!!! My car doesn't have the extra screw holes on the assembly but that doesn't mean you can't use them. Techinacally I shouldn't have been able to make them work. These lights are powered by your side marker lights. I couldn't use the screws but you can still use mechanic wire, adhesive, or make your own bracket. I used mechanic wire and it took me about an hour. It's easy, and I did it without any instructions and I'm 25.
Gaara
Reviewed in the United States on July 2, 2024
It’s a great product. A lot cheaper than the other ones for a pair for 2. Only problem is if you know how take the front bumper off it’s easy. But if you’re lazy like me. It’s best to take off the windshield reservoir under neath the rear wheel shield. You might need to buy new fender Linder clippers. They are very cheap tho. So it should be no problem. The driver side is way easier to put on. You just need go take off the air filter box. Easy to put back on. So don’t trip. Great device. I just hope it last.
Travis Wood
Reviewed in the United States on February 29, 2024
Installed on a 2016 Scat Pack Shaker with HID lights. Despite the lack of instructions, this is a fairly simple install. Pop the inlet covers off from the backside. Clean the area very well. Any dirt or debris will be visible through the clear inlet. Remove the plastic covers over the lights. Remove the screw that holds the washer fluid neck on the passenger side to make just enough room to squeeze the inlet tube in. Tight would be an understatement. Utilize the side marker on the passenger side to attach the pigtail wiring. Remove the air cleaner for the driver side. Do not over tighten the screws or they will break the plastic mounting surface. Use zip ties to tuck the wire along the backside of the grill.They are bright and look great. I've had them on for a week with no issues. If I have any, I'll update the review.
Jay
Reviewed in the United States on December 2, 2024
These does not fit !
Felipe duran
Reviewed in the United States on November 3, 2024
Easy install, didn’t have to take bumper off. I took air box out of drivers side (3 screws) and passenger side i unclipped the fuse box and moved it out of the way (did not have to disconnect) then unscrewed the 2 bolts holding the fuse box bracket to the car and moved it out of the way, then i was able to insert light into passenger headlight. I then unclipped side marker out of passenger side and plugged in wires then clipped side marker back in. Took me 30 minutes.
Rakesh
Reviewed in the United Arab Emirates on April 8, 2024
N
Recommended Products