Your cart is empty.
Your cart is empty.Razorback
Reviewed in the United States on June 10, 2025
(See ratings explanation below the review)I didn't use the carburetor yet but used the gaskets, air filter and pull start assembly. Gave new life to my mower! I also used the fuel line. While narrower than the line from the tank to the cutoff valve. Even though smaller, it worked fine. (Remember, the fuel is going through a small jet in the carburetor so anything larger than inside diameter should work fine.)My ratings system:5 stars...... I'm blown away by quality & value... a must buy! (I rarely give this)4 stars..... Pleasantly surprised, better than expected3 stars..... as advertised, got what I expected, any pros/cons balanced2 stars..... a little disappointed, I had hoped for better1 star ..... avoid, waste of time and money, junk (I rarely give this)
S. Molnar
Reviewed in the United States on May 7, 2025
I got this kit for the pull start recoil starter, I consider everything else as a bonus I replaced the carburetor and spark plug not to long ago therefore I am not able to say much about those products that came with this kit. I did have a bad experience though in the past from not using an original carburetor, no matter how much I tried to adjust things there was always some issues with it till I went for an original carburetor. As far as the pull start to me it seams to be just as a good build quality as the original. So far I am very happy with the parts that I have used so far from the kit and I am keeping everything else for the time when it will be needed.
Dr. Nick
Reviewed in the United States on May 2, 2025
Used this kit to replace the carburetor only on my Power Stroke 3100 pressure washer. Installation was simple. Everything you need to replace the carburetor is included (gaskets) plus a new air filter, recoil starter, extra fuel line/clamps, fuel filter (if your equipment has an external one). After installing this carburetor, the pressure washer started with the first pull. No adjustment is necessary. Ran through 4 tanks of gas so far and it performed flawlessly.This kit is a value with what is included for an average retail of $30. I didn't use the recoil starter, but it appears to be well made. I may replace mine anyway because the one in this kit placed the pull in a more comfortable spot.
bobwatts
Reviewed in the United States on May 12, 2025
The media could not be loaded.
Tracy S
Reviewed in the United States on April 4, 2025
This is a great kit. Has all the pertinent parts and pieces … plus the pull cord (which we didn’t realize was included). Have a push mower that is having some issues so look forward to installing this kit to get it back to working well.
conphil
Reviewed in the United States on April 13, 2025
My pressure washer has the Honda GCV190 engine as shown in first photo. It’s 14 years old and used a lot… so thought this parts kit (2nd photo) could assure tip-top maintenance.So, starting with the easy stuff first… the 3rd photo shows the air filter fits perfectly.Next easiest is the spark plug. 4th photo shows the OEM removed from my machine next to the new one from this kit. It’s clearly too small… no way I’m installing this!5th photo shows the pull starter recoil assembly next to the disassembled OEM unit… mounting holes too small. I guess I can drill them larger so the assembly can sit correctly lower. See 6th photo where the new assembly is not seated properly. Also in same photo note where the pull rope exits the unit too close to the gas cap. Referring back to first photo, note where the rope is supposed to exit the assembly out the side of the machine. This kit pull-rope assembly is unacceptable, so I’ll not be using it.Well, I saved the carburetor install for last. This one is a bit more complex. While I’m quite handy and have rebuilt many carbs in the past, I decided that I’d like some guidance to be sure I do it right. The Amazon write-up says “clear instructions” are included. You guessed it: no written instructions to be found. That carb may be perfect, but I’m not confident enough to go any further. There are way too many “red flags”. This whole package is ready for return, if prompted.
M. Ross
Reviewed in the United States on April 12, 2025
My review is going to focus on the parts themselves, as I haven't found the time yet to do the install. And simple small-engine carbs like this will almost always run well if the other engine parts are in good shape.So, a close visual inspection of the carb itself is favorable, as the screws, springs, and the moving parts (throttle, choke, etc.) all work as designed. If I were picky, I'd ding them on the machining (see photos), since the mating surfaces have obvious machine marks and some burrs. This probably wouldn't have affected performance, but I did dress those surfaces with a fine flat file to smooth them out.This kit is really nice for tired mowers like mine, in that it includes not only the carb, but also all necessary gaskets, a new air filter element, a new spark plug, a fuel line with pinch clamps, an inline fuel filter, and even a new recoil assembly. That last part was a nice addition for me, since mine has a tired spring and doesn't always want to return fully.All in all, this is a great tune-up kit for aging mower engines like mine. And after I get around to installing these new parts, I'm sure my mower will have a new lease on life. If not, I'll be sure to post a followup!In the meantime I'm happy, and this kit scores a 5 for me.
Recommended Products