Your cart is empty.
Your cart is empty.Product Description
To make things easier for you, we’ve created an installation video. It will walk you through the simple setup steps and help you confirm that all parts are complete and in good condition. Set up quickly and easily—no hassle, no worries!
Someone
Reviewed in the United States on June 9, 2025
Finally a hauler that holds my cans. 4 stars for bad instructions and unfinished/dangerous parts.
Aaron H
Reviewed in the United States on June 12, 2025
Works well. I do wish the pins to hold the trash cans on was designed a little better. Once you've got your trash cans in place it's very hard to get the locking pins in. I just don't use the pins and haven't had any issues yet, but it would be nice to be able to use them. Also the cross bar that holds the trash cans is held on by a single bolt, which makes the bar pivot if you're only pulling 1 trash can. I'll probably drill and tap another hole so I stabilize it better. Other than the few minor oversights in the design, it really is very handy, especially if you have a long driveway.
MRH
Reviewed in the United States on May 15, 2025
We have a long driveway and I dread taking out both the trash cans. This makes it so easy. I leave it hooked up on my SXS and grab the cans whenever needed. Make life so much easier!
Dana
Reviewed in the United States on May 13, 2025
This trailer hitch that holds two garbage cans with wheels is amazing! It's super easy to install into your hitch and it's made of heavy duty materials. Makes taking your huge cans to the road so much easier! Especially if you have a long driveway! It doesn't stick out behind your vehicle very far either. It's pretty easy to take off and on too. Also to get the garbage cans to connect to the thing, it's simple too and i haven't had a problem at all with the cans falling off . Even on my holey not so good dirt driveway with lots of bumps!
ERROR404
Reviewed in the United States on May 12, 2025
Assembles fast & easily with the provided wrenches. 11 bolts, washers, and nuts. The welds seem fine for the intended duty. I'm going to replace the provided pins with circular tractor pins. The issue i have is my trash bin lids won't allow me the clearance to click both pins on. It pivots just enough for small turns and stops before making contact with the bumper. I plan to round out the top corner of each holding bracket with a file. No need for them to be so sharp. I have another single can transporter. This allows me to do one trip full or empty. Easier on my back. So I am happy with it.
Recommended Products