Your cart is empty.
Your cart is empty.
Description:
- Enhance the look with this integrated LED Tail Light with Turn Signals
- This integrated tail light is direct replacement of stock tail light
- No modification required to fit the taillight
- You will need to splice the turn signal wires and attach to the taillight
- Professional installation is recommended
- Taillight consists of Running, Brake,(red) and Turn Signal Lights (amber)
Specifics:
- Quantity: 1
- Instructions: Not Included
- Condition: Brand New, Never Used
- Material: High Quality ABS Housing + PC lens
- Lens Color: The same as picture show
Fitment:
- 2003-2009 Suzuki SV650 / SV650S / SV650A
- 2003-2007 Suzuki SV1000 / SV1000S
Morne
Reviewed in the United States on March 4, 2025
Looks very very niceNo regrets in ordering this
Sean r.
Reviewed in the United States on April 19, 2021
Looks great on my sv650, but the light output is terrible compared to OEM. Turn signal function does work and I didnt need to use the ceramic resistors that where included. May need to if you dont already have a LED flasher relay. If you are going to buy, get the clear one as you will have better, still not great light output.
Ricardo
Reviewed in the United States on November 24, 2019
These lights are actually very bright! They look great and were easy to install. Yes you have to splice the cables so YouTube how to do it and it will be much easier!
Ryan
Reviewed in the United States on January 19, 2019
Super awesome integration and it looks great in my bike. Easy install and totally bright enough
JM
Reviewed in the United States on March 16, 2018
I installed this together with the Hotbodies undertail. They go very well with each other. Just like some of the other reviewers mentioned, some of the LED bulbs aren't quite in alignment but the overall look is good. You should grab some weatherproofing tape and do some research on YouTube or whatever before you pull everything apart.
Glenn Perez
Reviewed in the United States on May 6, 2016
Good fitment and good wiring. Long leads to work with. You will need weather stripping and or foam strip/insulation to take up the spaces around the light assembly. The Factory light has this but this unit does not. Also unless they did a PERFECT job on yours, you may have an LED or two slightly off angle. I had one but at the height of other drivers, the lights look complete and full. Be sure you get the proper resistors or flashing unit. it is not the voltage that's the problem, it is the length of time the flasher interval is. Too fast and the lights actually look dimmer when flashing. My unit had a very light smoke to it instead of the clear I though this was. Turns out it looks great. We will see how it lasts but unless something fails in the actual electronics, I expect this to last. Well sealed unit good fitment. I say give it a try.
Customer
Reviewed in the United States on March 15, 2016
Works great, and was relatively easy to set up. It's a bit of work removing the old lights (don't throw it out, you'll need the soft washers for the installation of the new part) but the electronics are pretty simple. You'll have to unplug your turn signals, but since I bought this to replace them it wasn't a problem. I wish it were a little brighter, so I suggest buying a clear version as opposed to the smoke color.
Jeff Jones
Reviewed in the United States on June 16, 2015
Great product, easy to install. Looks fantastic. I only wish I knew what the 2 whites ceramic boxs are for. Maybe resistor boxes? Fast shipping etc. Very happy with my purchase!
Recommended Products
