Shopping Cart

Your cart is empty.

Your cart is empty.

John Deere Original Equipment Knob - TY27749

4.7 (8) Write Review
Free shipping on orders over $29.99

$20.30

$ 9 .99 $9.99

In Stock
  • Genuine John Deere OEM Part Number: TY27749, Repalces: TY26583
  • Securely fits all steeling wheels up to 1 1/4" thick.
  • Recommended for lawn and garden equipment.
  • Split base design allows for quick, easy, and secure mounting.
  • Permanent John Deere logo - will not rub off. Green & Yellow logo.


John Deere Original Equipment Knob - TY27749 TM GNYB 2000 Deluxe Wheel Spinner Fits the following John Deere models: Part Master. This is an O.E.M. John Deere part. Thanks for looking!


John Gamble
Reviewed in the United States on May 7, 2025
perfect fit
David M. Scanes
Reviewed in the United States on January 16, 2025
Fit perfect on my John Deere tractor. Makes driving easier response faster.
Karl k.
Reviewed in the United States on September 14, 2024
item works very well good service
lunachick
Reviewed in the United States on May 31, 2024
added to an older model Gator with no power steering makes steering better .
frank
Reviewed in the United States on February 14, 2024
Item is as described. I have not installed it as of yet. Nothing else I could add at this time.
Tory R Oleck
Reviewed in the United States on December 14, 2024
considering that it carries the John Deere logo you would think that it would be a better fit. I mounted on my JD compact tractor and it doesn't fit the steering wheel very well. I made it work but it could be better.
Elizabeth ryder
Reviewed in the United States on October 22, 2024
I have been using the for 8 months now. It does take a little work to get it on, but work wonderful.
gary
Reviewed in the United States on July 5, 2023
I had high hopes for an original Deere product to use on my Deere lawn tractor. This did not meet those expectations. It comes with two sets of screws to allow it to be used on different diameter steering wheels which is great but even though I used the correct screws they would not tighten to the point where the know was firmly in place. The problem is there is a stamped steel “nut” embedded in the plastic which is designed to fail if you apply enough pressure to simply snug the bolts. I was going to return it but decided getting another one would come with the same issues so I decided to replace the bolts and nuts using a slight smaller size and make due.