Your cart is empty.
Your cart is empty. Organize your cables with professional desk and cabinet cable-pass through grommets. Cut hole to size specified and either press or glue into place.
Specifications:
- Cut-hole Size Required: 3.0.
- Grommet Insert Width: 2.973
- Grommet Lid Width: 3.484
- Grommet Depth: 0.689
- Inside Usable Diameter (Approx): 2.77
- Size Tolerances May Vary
Important Installation Note: The Grommets are manufactured to be slightly less that the hole size. For example if we have a grommet advertised at 3.0 inches (example size ONLY) when measured on a caliper it will measure at approx. 2.973 inches - or approx .027 inches LESS than the hole size of 3 inches. This difference is by design to allow for the grommet to be inserted into the CUT hole size. These grommets after inserted into a cut hole are intended to move freely. If you need a TIGHT fit a small amount of glue or silicon may be needed.
Please see technical drawing (Product Manual) below for size and shape details.
Customer
Reviewed in the United States on July 12, 2024
Works great with a three inch hole saw and was exactly as I expected it to be
homer k reyes
Reviewed in the United States on February 21, 2024
These are exactly what I was looking for these have a sleeve with a cap 3 inch hole perfect hole saw
EC
Reviewed in the United States on July 4, 2023
Did the job and worked as advertised
Don Roundy
Reviewed in the United States on November 8, 2023
works great and was easy to install
John S
Reviewed in the United States on September 29, 2022
They're not 3 inches. The hole in my desk is exactly 3 inches, and these are to small
Recommended Products
