Your cart is empty.
Your cart is empty.Mary Christ
Reviewed in the United States on May 29, 2025
It was what was ordered
Black Cat
Reviewed in Canada on May 26, 2025
Nice after market replacement
Susy D.
Reviewed in Canada on September 30, 2024
I purchased caps for my wrought iron chair legs but they didn't fit. I reached out to company even thought it was passed the return date to see if I cought exchange for correct ones. I sent photo of chairs and unfortunately they did not carry what I needed. They apologized for not being able to help me and refunded my order in total. Do not hesitate to order from Sunniland. Their customer service is A#1.
Sherryc
Reviewed in the United States on September 1, 2024
Most fit well without any force but a few of the feet on our chairs were bent from being older and rusty and required some force. Overall very happy with the purchase and hopefully this stops the rust rings all over the concrete patio.
Phil F
Reviewed in Canada on June 16, 2024
Used for inside chairs . Worked great.
charlie
Reviewed in the United States on May 29, 2024
Bought the wrong size. You have to consider the size of the inner cup and outer ring of the chair leg. Also look at the photos because theses have tread or bumps on the part that touch the ground. I can't say they will slide easily or not, but look like they would wear down and need replacing quickly.
Mark Schoenfelder
Reviewed in the United States on May 2, 2024
I know it’s a lot to ask that these would fit every patio chair. My chair had a 3/4” ID so these 3/4”Id & 1” OD replacement feet were a very close fit. I put each part in a vice and used a hack saw to just slightly widen the 3/4” slot to match the width of the chair foot cup. I used duct tape to hold the cap in place while I hit it with a mallet. All the chairs and the table have new feet let’s see if they stay in place.
Darryl
Reviewed in the United States on July 15, 2023
The media could not be loaded.
Susan in Alabama
Reviewed in the United States on July 11, 2023
I'm so glad to have found these to replace the 1" dry rotted glides that were on my 20 year old barstools.you might have to tap them in with a hammer, as they are hard to simply push in place. The good thing is they won't fall out!.I was afraid that they might not slide easily on my hardwood floor, but on the contrary, they glide effortlessly despite the weight of my stools. Sorry I couldn't get th pictures I took to download. I promise they look great.
Liz
Reviewed in the United States on July 20, 2021
These glides were specified to be used with a 1” inside diameter metal cup.As you can see in the photo these glides only measure 1”.They should have been at least 1-1/16”, or even 1-1/8” if the plastic is flexible enough to snap inside the cup.If the inside flange of your metal cup measures 15/16” these cups will work perfect.These are not molded right for a 1” cup, either wrong advertising or wrong molding..
Jackie
Reviewed in the United Kingdom on May 26, 2020
Used to replace lost cups on a metal patio chair. They are exactly the same as the cups on the other feet. One seemed a bit loose when replaced but tried a couple out of the pack and found one that fitted perfectly. There must be slight discrepancies with the sizing which is fine as you can mix and match to get a good fit.If you are buying follow the measuring instructions to ensure the cups are the correct size.Chairs now back to a stable condition with the fitted cups in place. No more grating noise as they are pulled across the patio.Only down side to this purchase is that I had to buy a pack of 16 when I only needed to replace two although I now have plenty of spares.The product arrived the next day, well packaged and in perfect condition.
Christopher E Skoog
Reviewed in the United States on September 1, 2019
Took me a minute to realize I needed to use a hammer to pound these in to the bottoms of the chairs. I rested the chair upside down on a bag of mulch and then just a couple of taps with a hammer and they’re on secure.Make sure to remove remnants of old caps. Also- helpful to rustoleum the legs/feet on wrought iron chairs before putting these on to address any in-foot rust on bottoms of chairs.Once they’re in though- no more worries.Very solid and durable. I can already tell these will hold up better than the others I’ve tried.
Recommended Products