Your cart is empty.
Your cart is empty. Used widely in milling machine, CNC engine lathe, gear shaper, hobbing machine, drilling machine or other machinery transmission occassions.
John
Reviewed in the United States on January 6, 2018
odd piece, make sure that you are ordering the right size
VTer
Reviewed in the United States on September 17, 2017
I also purchased the 20 tooth version and for some reason this 40 tooth version does not have the set screw holes and does not come with the set screws. The 20 Tooth version DID have two set screw holes at 90 degree opposing, and came with set screws (Uxcell a14041600ux0192). The problem was simple enough to solve by drilling and tapping my own set screw hole however.
Guillermo
Reviewed in the United States on July 24, 2016
If you don't have a drill press or milling machine, give this pulley a pass. If reaming the bore and installing a set screw doesn't phase you, then you may as well save a few bucks. A 10-32 set screw works great, and the bore is close enough that you can hand ream it to 8mm easily.
iounatta
Reviewed in the United States on June 9, 2016
The pulleys are great but if you need a larger bore make sure it is done properly or it will wobble as it rotates. I learned my lesson trying to drill them larger on a good drill press. Should have used a lathe.
carrie
Reviewed in the United States on October 2, 2016
Could use a set screw
jonathan castillo
Reviewed in the United States on January 9, 2016
2 stars only. Cause the advertising is totally wrong. When u buy this gears they are advertised with a motor that dont even fit on this gears.
Harvey W
Reviewed in the United States on February 10, 2015
Product has been received as described by the seller. Product very solid. Only negative point: You should bring some cruzante screw to secure an axis.
digitalcraftsman
Reviewed in the United States on December 21, 2015
No set screw hole. How am I supposed to attach this to the shaft?
Recommended Products
