Your cart is empty.
Your cart is empty.The in (Gas) quick disconnect for a Cornelius or firestone ball lock keg. This connector has a 1/4" barbed connection. Connects to 3/16" or 1/4" tubing and held in place using a hose clamp.
CD-V
Reviewed in the United States on April 3, 2023
The inner gasket or O-ring keeps failing, and thus leaks Co2. You can open it and try to adjust it to fix it, but it will fail again in a matter of time.
UCRDAVE
Reviewed in the United States on August 15, 2014
Works great but does hiss now and then and have to twist it to make it seal correctly .
mikew0w
Reviewed in the United States on June 17, 2014
This guy was working fine for me paired with The Carbonator :http://amzn.to/1nN9ydhThis morning I went to carbonate some water and when I removed the disconnect a rubber O ring fell out of the inside and it immediately started leaking.It is now useless and I am just outside the return window by 3 days.
FredL.
Reviewed in the United States on March 24, 2014
not what I ordered. There was no hose barb, but a threaded fitting. I understand a "hose barb" to be a tubular fitting over which a hose fits. Although that was not the case, I made a 3/8" tubing fit, and it works well. The picture is correct, but not the description. Good thing I wanted 3/8" tubing instead of 1/4".
RLR
Reviewed in the United States on February 6, 2014
Needed a use for my fallow kegerator system, figured I'd try carbonating my own soda water. The nipple on my CO2 regulator is 5/16" so I ended up using 5/16" hose and a combination of Teflon pipe tape and a hose clamp on the disconnect side. It works fine, and it's kind of nice to have a constant supply of seltzer.
S l J
Reviewed in the United States on January 5, 2014
This is exactly what I needed, I already had the adapter for the barb to hose. This is a perfect fit, no leaks and is just the right pressure to lock. It seems good construction as well
Kindle Customer
Reviewed in the United States on May 26, 2013
Product arrived quicker than expected and works great on my new Keg. The product I purchased has a threaded interface rather than the fluted one depicted in this picture. It was just what I wanted.
Sak!
Reviewed in the United States on March 24, 2013
What's there really to say about something like this. It either works or It doesn't.You would think that they would make It right but you don't get the part shown. They send you one that has threads. You can still use It alone without an adapter. That's what I did. I used 1/2" ID plastic tubing. It fit right on but also fit on to the regulator.Works just fine In fact It turned out better this way. Make sure you get half Inch ID tubing. It fit both ends perfectly. You still should use clamps and buy food grade tubing.
Recommended Products
$36.99
$ 16 .99 $16.99