Your cart is empty.
Your cart is empty.Do you enjoy reloading, but your back doesn’t? Perhaps a new Ergonomic lever is all you need to reduce discomfort and increase productivity. Our forward offset design snugs you into your press and positions you perfectly to see your powder charge before placing a bullet. It also keeps you from bending/leaning over time and time again through-out your reloading sessions. Couple that with a roller bearing handles that is super smooth, offers greatly reduced effort to use. Your back will thank you.
Ben C
Reviewed in the United States on July 15, 2024
Decided to change you my standard ball end handle with the In-line version which is much less expensive than the factory roller handle. I like this handle a lot! Should have done this long time ago!!! Well worth it.
dwayne
Reviewed in the United States on May 9, 2022
Installed in my Dillon XL750. Has great feel and overall economic. Great buy.
Bullet Bob
Reviewed in the United States on December 13, 2022
Ergonomic is the right word for this thing. The handle being slightly forward vs the other handled levers makes a big difference. Compared to the Dillon handles I have used this seems to make priming feel even smoother and easier if it’s possible to believe. Then position of the handle when you have it all the way down is nice. Always felt like I was pulling the handle to china with the standard one. The in-line handle ends putting my handle slightly above the bench. Also using the ulramount with this press and stand at the bench.
Michael Chan
Reviewed in the United States on July 16, 2021
This is the first and foremost upgrades and a Must for progressive press. It is beyond comfortable and feel vs the OEM handle.
Kenneth A. Baker
Reviewed in the United States on June 4, 2021
This is my third handle (I have three Dillon pressed), and like usual for and finish is flawless, and the ergo omics is what Dillon ought to have built in from the start.
Martianus Lucianus
Reviewed in the United States on November 10, 2020
I purchased the this prior to receiving my xl750. I therefore can’t comment on the comparison between this and the factory arm. What I can say is this is allows me to stand without bending while reloading. My bench was designed with the inline fabrication ultra mount in mind and the height of everything was important. When you are reloading for hours it’s also nice to have a good arm to run the press with. I am a former single stage press reloader and on my rock chucker I have the ball arm. It works on that press. But when running a multistage press I wanted something that was smooth and didn’t require me bending hundreds of times each hour. This arm fits the bill. Well machined and it works. I am very pleased with this purchase. I only wished Dillon included this on the press. They didn’t and I’m happy to support in-line fabrication. I have several of their aftermarket parts for my press and I am pleased with all of them.
William Dodgen
Reviewed in the United States on March 4, 2017
Great addition to my Dillon 650. I sat down a few weekends ago and loaded 1200 rounds of 223. At the end of the day I still wasn't wore out and my hand didn't have blisters on it from the handle. Well worth the money should have done it years ago.
Dirk Sanders
Reviewed in the United States on May 23, 2016
It's a bit pricey, but otherwise does exactly as advertised. I love it...
Recommended Products
