Your cart is empty.
Your cart is empty.Lang Tools (B-600) Heavy Duty Battery Carrier is designed for use on all batteries with horizontal ridges. With a sure-grip handle and heavy-duty, non-slip, acid-resistant, riveted rubber grip pads, the B-600 gives you a secure and firm hold on any battery up to 7-1/2" wide.
Daniel C Williston
Reviewed in the United States on January 15, 2025
Made removing, installing, and carrying batteries so much easier.
John C.
Reviewed in the United States on September 17, 2024
This is a must have tool to help you remove and to carry your old or new battery from or to your car.
Stan
Reviewed in the United States on May 11, 2024
Fix the battery up real good no problem
Customer
Reviewed in the United States on December 23, 2024
Will not work in tight areas and you have to make a few test runs to make sure it grabs the battery
c. tolson
Reviewed in the United States on December 17, 2024
I bought it with the hopes it would make it easier to remove batteries from Harley touring models, it's too large. However, it's great for it's intended use, automotive size batteries. I'm keeping it. Lange tools rarely disappoint.
RICO
Reviewed in the United States on December 1, 2024
Makes removing my car battery a piece of cake! You don't use it much but when the time comes, it's nice yo have this tool around. Definitely handy!
putergod
Reviewed in the United States on August 30, 2022
There is nearly zero chance I could have changed both batteries in my Silverado 3500 in less than an hour without this tool. It made carrying those heavy batteries, pulling them, and installing the new ones, so much easier!Advance Auto says: REQUIRES PROFESSIONAL INSTALLATION: DO NOT attempt to install batteries in this vehicle.; Installation may take up to 45 minutes. Battery located under hood.; OE Exact Fit; OE Spec: OE Group H6; OE CCA 730; Battery Spec: 730 CCA; 910 CA; 130 Minute Reserve Capacity; 3 Year Free Replacement; Auxiliary BatteryO'Reilly says: Difficult To Install Battery, Professional Installation Recommended; CCA: 760; CA: 875; RC: 120; AGM; Two Batteries Required, For Best Results, Replace Both Of Same Type; Battery Located In Engine Compartment, With Fuseblock On Top Of BatteryThis tool made what would have been the hardest part (removing and replacing in such cramped locations with such large and heavy units) MUCH easier.Buy now if you ever change batteries in your vehicles. You will NOT regret it!
Terry Condy
Reviewed in Canada on November 2, 2022
Clamps on easy has a very firm grip on several size batteries
Atties Daddy
Reviewed in the United States on April 5, 2022
I see other reviews complain about the pads or the sharp teeth or speculate how long certain parts will last. The motivating factor for my purchasing this item is that ITS MADE IN THE UNITED STATES!!This is not so much a tool for a company who’s business is in large part selling batteries. It’s made primarily for us part-time do-it-yourselfers that change a battery once a year or so. It’s rugged enough and like all tools, if you keep it clean and lubricate the pivot points, there’s no reason for it not giving years of service. I’ve used it twice just to test it out and it has preformed flawlessly. It was tested on a battery from my 4.0 Jeep and from my 327 in my pickup. Let’s keep it in the USA where we can. 5 stars overall.
Jason
Reviewed in Canada on July 15, 2021
I don't provide this 5-star review lightly. I needed it to transport a couple of large (100lb) 6V batteries and it has been working well for this ...I have confidence that the battery grip is good and that it won't slip out and break my toes :)The construction seems really good too (well made).Only minor complaint is that the orange handle grip slips a bit, and I either had to shift how I hold batteries, or temporary put it down to push the grip back on fully. Not a huge deal though - more on an inconvenience. Still recommend it for sure.
Solosurvey
Reviewed in Canada on October 15, 2021
Well built with strong handle and great grip. Have had to walk nearly a mile to the liquor store ever since I lost my license so I now use this to pack my box of beer home.works great.
alan tanner
Reviewed in Canada on September 5, 2020
Well finished quality product easy to use
Customer
Reviewed in Canada on December 6, 2020
I chose this battery lifter from the many similar products, because the photos of the competitors showed 2 spot-welds per side where this one didn't show any, which lead me to guess it was fully welded. Upon close inspection of the actual received product, 4 spot welds per side are visible, but the surface treatment has almost rendered them invisible. Both the double number of welds and attention to surface finish show a greater attention to detail, suggesting suoerior quality. The box is also unusually well-padded for such an item. The manufacturer stamp is Lang, of Racine Wisconsin, and made in U.S.A.
Recommended Products
