Your cart is empty.
Your cart is empty.Rig Rite Manufacturing Marine Black Rubber Rigging Grommet features a 1 7/8" overall diameter grommet. It comes in three different sizes for any rigging job.
TS
Reviewed in the United States on December 16, 2023
Works perfect for clean install of wires thru hull
Paul
Reviewed in the United States on April 30, 2023
Product arrived quickly and did exactly what it was suppposed to do.
Loyal Shopper
Reviewed in the United States on September 27, 2019
The product description is a bit ambiguous in that it implies that I would be purchasing a 3 piece set "...comes in three different sizes for any rigging job..." when in fact, I must conclude, those different sizes are available but do not make up a set since I received only a single grommet. There's even an image of the three different sizes as part of the product description. Caveat emptor!
Awp
Reviewed in the United States on December 30, 2018
Good quality. Material is a little stiff but worked out great for my use.
JUSTIN C.
Reviewed in the United States on June 30, 2016
Love this grommet. I was able to run my fishing finder cables through my boats transom. Looks very professional.
E.A. K.
Reviewed in the United States on March 17, 2016
I recently bought the car I've wanted for a long time, a BMW Z3 convertible. The previous owner replaced the radio antenna and he replacement did not have a rubber grommet so the opening in the sheet metal of the rear fender was just a hole. This worked perfectly to slide over the antenna and rests at the base of the antenna against the fender, keeping it relatively water tight and looks much better.
Insider Carpentry
Reviewed in the United States on November 28, 2015
I needed something that I could use to run a cord out the bottom of my cargo trailer to plug my cord reel into home outlets. This is perfect for the task.
Pintail
Reviewed in the United States on April 23, 2014
I use it on my boat to run wires through the dash. The reason I gave it 4/5 is because the quality could be better. Don't get me wrong it works fine, just rough around the edges and the slots that are cut in the center are not on center. I would recommend these for hiding wire openings, and guarding wires from sharp edges.
Recommended Products
