Your cart is empty.
Your cart is empty.Product Description
MZS is a professional supplier who always supply high quality vehicle accessories. Providing the best service and innovative technology always are our pursuing. Once you run into any problem, please feel free to MESSAGE us.
MZS Jack Pad Adapter
- Each MZS product would be tested before factory, so it is safe.
- MZS pads allow to safely lift your Corvettes without risk of damaging your rocker moldings or frame rails.
Fitment :
1997 - 2025 Corvettes C5,C6,C7,C8
1997 - 2025 964 993 996 997 944 911
1997 - 2025 Caymaner
1997 - 2025 Cayman
Notice :
- Easy to install with Allen Wrench, no drilling required.
- DO NOT OVER TIGHTEN
High Quality
MZS jack pads are made of high quality T-6061 Billet aluminum material and anodized red.
Packing Accessories
4 x Black Jack Pads
8 x Bolts
4 x Gaskets
1 x Allen Wrench
Easy Installation
1. Pass two bolts through the holes of the pad and connect the gasket;
2. Insert the gasket end into the chassis hole and rotate to make the gaskets hang on the chassis;
3. Use the allen wrench to tighten the bolts.
Customer
Reviewed in the United States on November 6, 2024
*****
Ronald Capone
Reviewed in the United States on January 23, 2024
They fit perfectly. Very to install. They were exactly as they were advertised.
Philip C Basile
Reviewed in the United States on May 10, 2023
Bought these since they seemed to be the best fit although they were made for a different car. Some Mach e users used them with only one bolt since they will not fit wit both bolts. I decided to use both bolts but it required some modifications. Each puck required a 3/16” cut of the puck leaving a flat on one side so the puck would clear the outside plastic rail. The back ones fit perfectly using the threaded block insert. The front ones however had a chassis hole which was much smaller than the rear one. Therefore it requires the block to be cut 1/8” on each side and round the edges so it would fit. Now have a great installation using both block bolts.
MAT
Reviewed in the United States on December 12, 2023
After watching a utube, I saw how super easy it was, didn't have to jack the Corvette up, couldn't be better.
Canadian Gypsy
Reviewed in the United States on October 19, 2023
Had these over a year now ... can't comment on the installation or durability once installed ... can tell you these appear to be really well machined & seem to come with great quality hardware ...
Millz
Reviewed in the United States on December 29, 2022
They seem OK so far. They were somewhat easy to install. Your car will need to be on a ramp to lifted. Once the vehicle is in the air, they were fairly easy to install. But i can't review durability or longevity as of yet.
Erastus
Reviewed in the United States on November 20, 2022
I placed them in the slots under my Corvette a year ago, and they are still screwed tight, They are there to show were to place the jacks to lift the Corvette safely in the air. great produce
Smith
Reviewed in the United States on October 13, 2022
These jacking pucks look great. Everyone who sticks their head under my car exclaims, "Wow those look great," after they finish screaming in terror because they have stuck their head under a moving car.A couple limitations - not removable with a simple twist and pull like some other pucks. If you ONLY use these pucks and never a shop or different lift this will not be an issue for you. Each one uses two allen screws and a wrench is included.Second limitation is the allen screws have a tendency to work themselves loose. A drop of silicone or use of a lock washer is recommended.
Recommended Products