Your cart is empty.
Your cart is empty.Big Horn 19176 10 Inch Table Saw Blade Holder. Safely store any 10" or smaller circular blade - table, miter, panel, and circular saw blades; convenient hanging hook lets you keep blades on your shop wall for easy access. Includes knob and washer. More Information Model# 19176 UPC 766565191767 WARNING California Proposition 65 Brand Big Horn
JJ
Reviewed in the United States on March 7, 2025
This accessory will hold 2 blades. However, the threaded thumb screw is too long and I had to cut off about 1/8" so it would lay flat. Other than that, it worked fine. Other reviews mention the hanging tag is brittle and snaps off. If I were to hang it, I would reinforce the tab with JB Weld epoxy or something similar.
ALF Engineer
Reviewed in the United States on March 23, 2025
Wanted to like it more. It does the job of securing my extra miter and table saw blades but on both that I bought the embedded nut spun free in the plastic and had to be glued in place. That sort of worked for a while but the gorilla glue I used didn't adhere well to the case so now the nut needs to held with a wrench when tightening
Gary
Reviewed in the United States on February 17, 2025
These are great for protecting your expensive saw blades. I made a cabinet that these saw blade holders fit into keeping them organised and easy to access.
F. Kerby
Reviewed in the United States on February 11, 2025
This was just what I though I needed for the 10 inch Trex cutting blade I purchased until I tried to substitute a 1/4-20 fastener for the one that came with the blade holder. Thankfully I had a 6mm screw that worked just fine. Otherwise a great blade holder.
Jim White
Reviewed in the United States on April 21, 2025
It holds up to 3 blades, and keeps them handy to the saw. Appears well made with good hardware.
Woodsmithy
Reviewed in the United States on April 4, 2024
I’ve owned several of these blade holders over many years. The problem with them is the plastic tab doesn’t stand up to everyday use. Because I hang most of my blades on the wall, I devised a reinforcement for the tab.I attached a 1/4” thick piece of plywood 3/4” wide and 2 1/4” long. Then screw it from the back with two tech screws and open up the hole from the backside with a 5/16 drillbit. To dress it up, I masked off the holder and used some black paint on the tab as shown in my photographs.Granted this is a lot of work for something that should be made better. But I haven’t been able to find a better blade holder, so I modified these. After the reinforcement, I’ve never had a problem with these blade holders and they protect the blades very well.
Chad D.
Reviewed in the United States on August 23, 2023
The hanger tab broke off as I removed the item from the bag. About what I have come to expect from Amazon and it’s products Proudly Made In China
Mom Cathy
Reviewed in Canada on February 9, 2023
Holds a number of blades and keeps them protected. Easy to use
Mijoka
Reviewed in the United States on December 17, 2022
I modified it for my needs , I shorten the bolt , could have bought a shorter one , replaced the large wing nut by a flat bar I threaded it reason I want a low profile unit with fast access drawer type .Dado could be store there too you need to replace the bolt with a longer one , in my case loose too much space , beside dado is a type of blade I seldom use , i went around and set the dado blade on the box as well . so yes you can put the dado blade
Kurt Birkmann
Reviewed in Canada on November 3, 2020
The product keeps my table saw blades organized and safe.
Recommended Products
